>

Drivers are increasingly installing a DVR in their cars. This is due to the frequent occurrence of illegal actions by road service employees or the risk of accidents. In the event of such situations, the recorder helps to fix the incident. Today, buying a DVR is not difficult, but you need to choose the right mount.

Consider common ways to install video devices.

The main task

Installing the DVR allows the driver to save money in adverse situations. When they demand a large amount of money from him or an accident has occurred, the person will have proof of the actual course of events. For this reason, a recording device must be acquired after careful selection. Its attachment must also be properly selected in order to have maximum image coverage.

Читать далее о выборе крепежа для видеорегистратора-->Современный рынок предлагает широкий выбор приборов для записи. Они имеют не только различный набор технических характеристик, вроде частоты, длительности и качества захвата, но и какого типа будет крепление. Ассортимент включает как классический держатель на присоске, так и современный, с использованием хомутов.

Installation benefit

The DVR is a small device, whose main task is to record on the video series everything that happens on the road. In most devices, the possibility of fixing and audio. This is a useful assistant who can become the “main witness” in a traffic accident to protect the driver’s rights.

The presence of the video helps the accident participants to find the culprit.

Due to the constant increase in the number of cars on the roads, there is an increased risk of accidents. Special attention is required from the traffic police officer, and it is difficult to keep track of the violator. Also, some of the controllers decide to arrange for themselves an illegal "increase" in salary, extorting money. In this case, the quality of the recording of the incident depends on the mount that the DVR holder has.

When attaching a video system, you need to choose the right place. It should have an optimal angle for recording and not block the view to the driver. Also, much depends on the direction of the camera. It should be tilted slightly to grab part of the hood, and not just the road in front of you.

Fixing features

When buying a device, you need to pay attention not only to its technical parameters, but also to the method of installation. On this depends not only the ease of management, but the quality of the recording. An inaccurate attachment or a bad holder may prevent the incident from being captured or the frame will be covered by a foreign object.

Basic installation methods:

• on suction cup;
• sticking;
• embedded element;
• panel mount.

Suction cup - the most popular option for installation

The simplest holder is a suction cup mount. To use it, degrease the surface where the device will be fixed. The driver needs to wait until it is completely dry, and only then put the holder. It should be understood that the installation on the suction cup is far from the most reliable method. The device may fall out of place during strong shaking or water penetration under the fastening element. This is a budget option for drivers who prefer a quiet ride.

Sticker features

Fastening the DVR to such a holder is, in fact, the use of double-sided tape. The best reinforcement seat is on the windshield. So the product will get a fairly wide angle of coverage, and will not block the view of the road to the driver. If the design features still interfere, you can install the product behind the mirror itself.

Advantages:

• high percentage of adhesion to the surface, so the design has excellent strength;
• cost at the level of budget models;
• once having fixed the capture device, it will not fall even under a strong crash;
• Suitable for installation on any surface.

Double-sided tape usually comes with the device

Disadvantages:

• not suitable for multiple attachment and detachment;
• the product should not have a lot of weight, otherwise after a certain period it may fall;
• installed in only one place;
• under the influence of direct sunlight the adhesive weakens, and there is a risk of the apparatus falling.

If the driver buys this type of DVR, the parking should be in the shade. In cold or hot weather it is better to use the garage Discounts for new cars! Profitable loan from 9.9% installments 0% adom.ru, since the double-sided tape in the device becomes weaker under these conditions. Incorrectly installing the holder, you will have to buy fresh tape, which is not always better than the original.

Front View Camera

Some devices can be fixed to the panel. Often used for this double-sided tape. However, in the case of this fastener, its quality will be somewhat higher. For the device, choose a panel with plastic, with which adhesion is better than with glass. This also increases the service life, since the surface is not exposed to the influence of sunlight.

The main advantage is greater adhesion to the mounting surface.

The main advantages of this method in its practicality and endurance. The DVR is easy to install with your own hands, it is easy to remove. Often, a separate panel is provided for this to remove the recorder if necessary.

Among the drawbacks, it is worth noting the apparent location that attackers can take advantage of. A similar wiring situation that is noticeable in a car is not aesthetically pleasing. As a rule, devices of this format do not provide complete capture of the environment, so they may miss an important point.

Built-in mirror models

Such devices have appeared recently. They differ in the method of fixation, raising its quality. But with this method it is not easy to fix the recorder on your own. The help of a specialist who will inspect the mirror and propose a solution will be required. Without the necessary skills you can only damage the machine. Some models have a lot of wires under the holder, which have somewhere to hide, while others can work from the battery, so you can make them yourself.

Recently, similar models began to gain popularity.

The advantages of this method are in the quality of attachment. The device will not fall from its location during strong vibrations and temperature rises. It is almost invisible at the installation site, so it does not attract unwanted influence. Such DVRs can be synchronized with other motion control devices, including the navigation system. The capture angle of this recorder is much higher, which directly affects the price.

DVR under the mirror mount requires the obligatory assistance of the master. Car service services will also be needed when unplugging the device. Despite the increased cost, the device provides continuous operation when powered by the vehicle system. Such a recorder is ideal for those who need to get high quality video, despite the cost.

Important Tips

In the process of fastening difficulties may arise. They are associated with the specifics of the model of the registrar, as well as a place under the holder. If you use the type of fastening using double-sided tape, you need to monitor the tightness of the tape. There should be no air voids, as they impair the quality of adhesion to the surface. When driving carelessly, the DVR may fall off.

Not all devices have a system for hiding wires - this must be foreseen in advance. During the installation of the cable it can be hidden in the corners, fixing tape. You can cut the "channel" in the casing of the machine to hold the wire in it. Not all models of devices can provide optimal capture of the video, so many attach them to a visible place. If you need to capture an offense on the part of a person, he will purposely go out of the zone of visibility of the registrar.

If the power wires interfere, they can be hidden.

In winter, the fastener may lose its properties, because the device must be removed. From overcooling, the recorder may also show incorrect data or shoot video with noise. When attaching to tape, you will need to remove the device and reinstall it in warmer weather. The situation is similar during a heat wave in order not to overheat the system.

Today the market offers a large set of fasteners. They adequately replace the classic suction cup systems. This allows for more efficient and reliable fixation of the surveillance system. Since drivers are not always able to drive only on high-quality roads, a poorly fixed apparatus may fall away when shaken. To do this, you need to choose the right holder and test it, applying a manual effort to it.

When installing the DVR is better to use the advice of a specialist. In the absence of proper skills, it is difficult to choose a place that will provide high-quality recording. The master will be able to lead a reliable and inconspicuous installation that will not cause inconvenience.